Abicor Binzel iROB Control Mode D'emploi page 49

iROB Control
Alarm codes
E01 E02 E03
E06 E10
E07
E08
E11 E19
E12
E13
E14 E15 E18
E16
E17
E20
E21 E32
E22
E29
E30
E38
E39 E40
E43
E44
Tab. 12
BAL.0333.0 • 2017-08-31
Type Description
Alarm Temperature alarm
Alarm Power module
Alarm Wire feeder motor supply
Alarm Motor blocked
Alarm System configuration
Alarm Communication WF-DSP
iROB Feed
Alarm Communication FP
iROB Control
Alarm Program invalid
Alarm Communication RI
Alarm Communication µP-DSP
Alarm Memory error
Alarm Data loss
Alarm LC display DSP
Alarm Incompatible measurement
results
Alarm Faulty communication
between components
Alarm Undervoltage
Alarm System power supply
Alarm Coolant running low
Alarm Gas shortage
Explanation of the error codes
10 Troubleshooting
Possible solution
Observe the duty cycle
Internal error. Call Service.
Internal error. Call Service.
Check that the wire feeder system, incl.
liner and wear parts, is running smoothly.
Incorrect firmware in a component. Call
Service.
Check cabling.
(Intermediate cable assembly)
Check cable to operating panel (incl.
plug).
Reset the power source. If error persists,
call Service.
Check power supply for interface.
Internal error: Call Service.
External error: Check voltage (+24 V).
Reset the power source. If error persists,
call Service.
Reset the power source. If error persists,
call Service.
Reset the power source. If error persists,
call Service.
Reset the power source. If error persists,
call Service.
Power source may currently be in test
mode for the electrical safety test. Call
Service.
Check cabling.
Have the mains voltage checked by
skilled personnel (at full load).
Have the mains voltage checked by
skilled personnel (at full load).
Call Service.
Refill the coolant.
Increase shielding gas volume.
EN - 21