Installation / Connection Diagram - Quick SPA Sigmar marine TERMOINOX B0 10 UAS Manuel D'installation Et D'utilisation

INSTALLATION
• Put mounting on the tank using studs and nuts provided.
• Fix water heater on flat or inclined plane or wall, as shown in fig. 1, using proper mountings for the weight of the water
heater and for the type of installation site in the boat.
WARNING: the weight of water heater/unit in the technical data refers to the empty unit. In order to have the
gross weight add to the empty weight, the water amount. (1 liter of water will almost weigh 1 Kg. / 2,2 lb).
• Carry out the hydraulic connections, relating to the input and output of tap water and from the engine cooling to the
heat exchanger, as shown in fig. 2. Keep the connections between engine cooling system and heat exchanger as short
as possible.
WARNING: the overpressure release pipe must be positioned sloping evenly downwards in a location protected
from the formation of ice.
WARNING: water might drip from the overpressure release pipe of the device, and this pipe must be left open to
the atmosphere.
INSTALLATIONS EXAMPLES
FIG.1
CONNECTION DIAGRAM
FIG.2
TAP WATER TANK
BOILER ARDINOX - REV001A

INSTALLATION / CONNECTION DIAGRAM

HOT TAP
WATER OUTPUT
ENGINE
COOLING LIQUID COLD TAP
WATER INPUT
EXPANSION TANK
AUTOCLAVE
HOT WATER
COLD WATER
EN
9