Troubleshooting; Functions - Interlogix TVM-1700 Manuel D'utilisation

The monitor's installation surface is compatible with
other types of VESA standard stands.
Hole spacing: 100 x 100 mm
Screw length: 8 to12 mm

Troubleshooting

Symptom
Picture is jittery
No picture
POWER LED is
not lit
Image is unstable
Image is not
centered, too small
or too large
User Manual
Check
Adjust Clock to set the
screen position and adjust
Clock value carefully until a
noise is no longer
displayed.
Check if the power switch
and computer power switch
are in the On position
Check if the signal cable is
correctly connected to the
video card.
Check if the pins of D sub-
connector are not bent.
Check if the computer is in
the power- saving mode.
Check if power switch is in
the On position.
Check if the power cord is
correctly connected.
Check if the signal cable is
suitable to the video card
Adjust Clock or H&V
Center to get the proper
image.
Symptom
Picture bounces or
a wave pattern is
present in the
picture
Picture is blurred
No sound
Low sound
VIDEO screen
cannot be seen
No video
Poor color in the
video
Grainy picture in
the video
Check
Keep the devices that may
cause electrical interference
away from the monitor.
See the FCC information at
the front cover of the
manual.
Adjust Contrast and
Brightness.
Check the audio cables are
correctly connected to the
computer.
Adjust the volume after
checking the sound is
muted.
Check the audio system in
the computer.
Adjust the volume on the
OSD menu.
Adjust the volume of the
sound card in the computer.
Check if PICTURE mode
has been set.
Check if the video terminal
is properly connected.
Check if the video cable is
correctly connected to the
computer and set to

Functions

on the OSD
picture menu.
Adjust the Color or Tint
values on the OSD Picture
menu.
Adjust the Sharpness
the OSD Picture menu.
9 EN
on