Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
WITH PAR PROJECTOR, STROBE, MOON & LASER
Safety Recommendations
•
Please read the instructions carefully. They contain important information about the installation, operation and
maintenance.
•
Keep this User Manual for future reference. If you sell the unit to another user, be sure that he also receives this
instruction booklet.
•
Unpack and check the unit carefully that it has not been damaged during transport before using the unit.
•
Before operating, ensure that the voltage and frequency of power supply match the power requirements of the
unit.
•
The unit is for indoor use only in a dry location.
•
It is essential that the unit is earthed. Only connect to a wall outlet with earth connection.
•
The unit must be installed in a location with adequate ventilation, at least 0.5m from adjacent surfaces. Be sure
that no ventilation slots are blocked.
•
Disconnect mains power before fuse replacement or servicing.
•
Make sure there are no inflammable materials close to the unit during operation.
•
In the event of serious operating problem, stop using the unit immediately.
•
The light sources of the light effects are not replaceable. If a light source is faulty, the light effect must be dis-
carded.
•
Do not touch any wires during operation as high voltage might be causing electric shock.
•
The product is for decorative purposes only and not suitable as a household room illumination.
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall
remain readily operable.
DO NOT OPEN THE HOUSING
Installation of the units
Before positioning the light stand, ensure the stability of the installation site. Drive the screw into the screw
hole on the stand. Make sure that the units can't fall from the stand. The manufacturer cannot be held res-
ponsible for damages due to bad installation of the units.
Connections
1.
Power supply input: Attach the IEC mains cable here. Built-in fuse
2.
DMX input: 3-pin XLR connector for DMX512 signal input
2
MANUAL - DJLIGHT85LED
INSTRUCTIONS FOR USE
LIGHT STAND
CAUTION
SHOCK HAZARD
©Copyright LOTRONIC 2018
7
Publicité
Table des Matières
