Initial Operation; Using The Machine - Clatronic HM 2935 Mode D'emploi & Garantie

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Ensure that the machine is not connected to the mains.

Assembly of the Whisk/Kneading Hook/Beater

Press the two whisks or kneading hooks on the bottom by turning slightly until

they lock in place.

Note: The kneading hook/whisk must be inserted into the correct opening of the

mixer!

1. Please ensure that the speed switch (2) is turned to „0/OFF".

2. Connect the mixer to a properly installed power socket, 230 V, 50 Hz.

Always choose a utensil and a speed according to the following table

Product/Type of Preparation

Heavy dough (e.g. yeast dough)

Cake mixture

Sponge mixture or wafer mixture

Cream or beaten egg-white

Liquids, shakes

Note:

For optimum results use high-walled vessels that are not too large. Tilt the machi-

ne slightly up and down.

Turbo Switch (1)

This is for switching to maximum speed for a short time. Press at short intervals

for pulsed mode operation.

WARNING: Do not use this function for more than 2 minutes!

Releasing the kneading hook / whisk

•

Ensure that the machine is not connected to the mains.

•

In order to release the hook, press the release button (3).

1. Before cleaning the equipment, always remove the mains plug from the

socket.

2. Only a damp cloth should be used for cleaning the outside of the machine.

3. Do not use any caustic or abrasive detergents.

4. Removable parts that have been in contact with the dough or mixture (knea-

ding utensil and whisk) can be cleaned in soapy water.

6....-05-HM 2935 26