HumanTechnik Tiviton 24 Mode D'emploi page 25

Receiver
Insert a battery into the receiver with correct polarity.
Operation
1. Switch the sound source (TV-set, stereo set), which has been connected to the transmitter,
on. The green power LED indicator will of the transmitter will glow constantly when the
incoming audio signal of the sound source is detected.
2. Move the ON/OFF switch on the receiver to the ON position. The green LED indicator
on the receiver will glow.
3. Adjust the volume as desired, put the receiver on and enjoy your transmission.
Excessive sound pressure can cause hearing loss!
4. When the battery charge starts to run low, the green LED will start to blink slowly and a
beep can be heard every minute. Recharge the battery.
Note:
Make sure that the batteries included in this set are fully charged before using them for the
first time. Charge the battery for about 3 hours before first use.
RF transmission of the transmitter will automatically switch OFF in approximately 5 minutes
if there is no audio signal, or the signal that it receives from the audio source is too weak for
proper reception. However, if the signal returns to an acceptable level, the transmitter will
automatically switch ON again.
Tiviton_DAB.indd 25
English 25
13.12.2018 14:26:05