Overview Of The Components - Clatronic BS 1295 Mode D'emploi

• Do not suck up liquids!
• Do not suck up hot ashes or pointed or sharp objects!
• Do not use the device in damp rooms!
• Never use without the filter. Check that the filter is inserted correctly!
• Hair, clothing and body parts away from the vacuum nozzle during
use!
• Keep the vacuum cleaner away from sources of heat like radiators,
ovens, etc.!

Overview of the Components

1 Air slide
2 Telescopic suction pipe
3 Holder for accessories and hook for stowage clip on the
bottom of the device
4 Slide for telescopic suction pipe
5 Floor nozzle (with hook (not shown))
6 Lever for extending and retracting the brushes
7 Power cord with plug
8 Cable-winding button
9 Stowage clip
10 On/Off button and suction power control
11 Cover for extraction filter
12 Dust bag filling display
13 Connection head of the vacuum hose
14 Hose connection
15 Opener dust bag compartment
16 Suction hose
Rear side of the device (not shown):
Storage compartment with dual accessory (combined crevice
and brush nozzle)
Start-up
• Insert the connection head of the suction hose into the
hose connector until it locks in place. To do so, please
press the buttons simultaneously. In order to release the
hose again, please press the buttons once more on the
connection head.
• Keep the buttons pressed down and then pull out the hose.
• Insert the vacuum tube into the handle if required.
• Then assemble the floor nozzle and/or the accessories.
Nozzle Attachment
Floor nozzle (5)
The floor nozzle features castors for easier movement.
You can clean smooth surfaces and carpets with the floor
nozzle.
• Adjust the brushes outwards or inwards using the lever (6).
Best use of the appliance depends on the texture of the floor
covering. We recommend the following use:
• Use without brushes:
For vacuuming floor coverings with a deep pile
• Use with brushes:
For vacuuming smooth floors and carpets with a shallow
pile
Crevice and jointed nozzle
For vacuuming upholstery, curtains and in corners and crevices
etc.
The stowage compartment with the crevice nozzle and brush
nozzle can be found on the back of the appliance next to the
mains cord.
NOTE: "2-in-1" nozzle:
When this is folded together it can be used as a groove
nozzle. If you would like to use the brush nozzle, pull the
brush section in the direction of the arrow until it locks in
place.
To detach the nozzle attachments from the suction pipe, pull
them off by turning them slightly.
Telescopic suction pipe
The length of the telescopic suction pipe can be adjusted
individually:
1. Loosen the locking mechanism by sliding
and holding the button (4) in the direction
of the arrow marking.
2. Extract one tube from the other to the
desired length.
3. Release the button in order to lock the
connection.
Mains cable
Pull the mains cable from the cable compartment.
31