Tips & Suggestions - Swann Maxi-Brite PNP-150 Instructions D'utilisation

Viewing the Camera on Your TV or VCR
Viewing the PNP-150 on a TV
After connecting the PNP-150 Camera directly to your TV and powering it on as
described on page 4, tune the TV to the correct input channel.
On your TV's remote control, the input button is usually labelled as Input, Source,
A/V, Channel 0, AUX etc.*
Viewing and Recording the PNP-150 on a VCR
Connect the PNP-150 into an available input channel on your VCR in the same
manner as the TV connection listed on page 4. Turn on your VCR and TV as if
you were about to play a VCR tape.
On your VCR's remote control, find the input button with is usually labelled as L1,
L2, Input, Source, A/V, Channel, 0, AUX etc.* Insert a tape and push record to
record the camera.
*Consult the TV or VCR instruction manual for details about changing input
channels
Tips & Suggestions
Never aim the camera directly at the sun as it may damage the sensor
Test all connections and ensure the camera is working correctly prior to permanent
installation
Install cameras high enough or out of reach to avoid tampering
Place Security Stickers in a visible location to alert potential thieves they are being
monitored
Mix real cameras with dummy cameras to give the impression of increased security
coverage
Purchase a Swann DVR to record multiple cameras simultaneously and easily moni-
tor your property.
Place cameras in high traffic areas such as doorways to maximise security
Use only the included Power Supply and do not modify or cut wires
6 6 6 6