Important; Checking Functioning; Maintenance; Spare Parts - Lotus CW-74G Instructions Pour L'installation Et L'emploi

Important!

After having carried out the conversion to another type of gas, it is necessary to update the data plate, indicating the
type of gas for which the appliance has been converted.
• The appliance contains the instructions necessary for use.
• Check the appliances for gas leaks.
• Examine the flame of the pilot burner; it must lap the thermocouple and be blue, otherwise examine the nozzle of
the pilot burner.
• Check the lighting and flame of the main burner.
• We urge the user to follow the instructions when using the appliance.
With prolonged use of the appliance, it is essential to carry out regular maintenance for the safe functioning of the
appliance; we therefore recommend drawing up a contract for after sales service.
Maintenance must be done only by specialized personnel, observing the norms in force and our indications.
It is possible to substitute parts such as: gas cock, piezoelectric device or gas piping in a very simple way. To substitute
the parts, proceed as follows:
• Cock: after taking off the front panel, unscrew the screwed fittings from the gas connections and the thermocouple
fitting, after which, substitute the cock.
• To substitute the thermocouple, unscrew the fitting of the pilot burner, likewise unscrew the thermocouple fitting
and substitute the element.
• The spark plug must be unscrewed and substituted.
Attention! In the event that smoke is given off when the appliance is started up, it is necessary to leave the appliance on
without being used for approximately an hour or until the smell disappears.

LIGHTING AND ADJUSTING THE MAIN BURNER

On the front panel, above each knob, the burner it corresponds to is indicated by the index
To light, turn the knob to the left from position "0" to the
keep it pushed down and press the button with the
Keep the knob pressed a few second and then let it go, this lights the pilot.
If the flame goes out you have to repeat the procedure.
By turning the knob round to the
By turning the knob round to the

Turning off the appliance

Push and turn the knob into position "0". This command blocks the gas supply to both the main burner and the pilot
burner. To relight the appliance, it is necessary to turn the knob again into position * and press the button.
The drip pan must be checked regularly and emptied before getting full. In any event, the pan must be cleaned after
switching off the appliance.

INSTRUCTIONS FOR DISCHARGING GAS EMISSIONS

Type "A" Appliances (See data plate)

Type "A" appliances must discharge the products of combustion into extractor hoods or similar devices connected to
and efficient chimney, or directly outside. (Natural Discharge) Fig.1.
If there is no hood, as an alternative, an air extractor connected directly to the outside is acceptable, (Forced
Discharge) Fig.2, but its capacity must not be inferior to what is established in item 4.3 of the UNI-CIG norm 8723.
GB

CHECKING FUNCTIONING

MAINTENANCE

SPARE PARTS

INSTRUCTIONS FOR USE

To switch off, move the knob back into position " 0".
IE
IT CH
position the burner is at maximum
position the burner is at minimum.

DRIP PAN

25
symbol (see figure);
symbol until the gas lights