Locking Mode - Briteq COB PAR56-100CW Mode D'emploi

ENGLISH
 Once the correct mode is shown on the display, press the ENTER button to confirm.
Note: SQUARE is the best choice for smooth dimming of LED lighting.
LAMP BEHAVIOR
Used to select the behavior of the projector while it is dimmed
 Press the MODE button until BEHAVIOR is shown on the display.
 Use DOWN and UP buttons to toggle between:
 LED: the projector reacts instantly (without any delay) to the DMX-control signal.
 HALOGEN: the projector imitates the behavior of a traditional halogen lamp. The afterglow effect
introduces a certain delay in the reaction time of the projector. Dimming will also be a little smoother.
"NO DMX" BEHAVIOR (BLACKOUT MODE)
Used to select the behavior of the projector when DMX fails (no DMX detected).
 Press the MODE button until NO DMX is shown on the display.
 Use DOWN and UP buttons to toggle between:
 BLACKOUT: output turns black while no DMX is detected.
 FREEZE: output based on the last valid DMX-signal is kept on the projector.
Note: as soon as the input detects a DMX-signal, blackout or freeze mode will be cancelled.

LOCKING MODE

Used to lock the control panel against unauthorized altering of the settings.
 Press the MODE button until LOCKING is shown on the display.
 Use DOWN and UP buttons to toggle between:
 OFF: the controls are always available.
 ON: after about 30 seconds the controls are automatically locked to avoid unauthorized altering of the
settings in the setup menu. To unlock the controls press the following buttons in the correct order: UP,
DOWN, UP, DOWN, ENTER.
CHECKING THE FIRMWARE
Used to check the current firmware in the unit.
 Press the MODE button until FIRMWARE is shown on the display
 The current software version is shown on the display.
Note: you can always check the download zone of the product page on our website. If a higher software
version is available, it can be uploaded using a special firmware upload device. Further instructions for
upgrading are included with the downloaded software.
OPERATING INSTRUCTIONS
Note: when the projector is switched on the display shows "UPDATE WAIT ..." This message informs you
that IF you want to upgrade the firmware, you should do it while this message is shown on the display. For
normal use you can ignore this message completely.
A. Standalone 1unit:
 Just connect the projector to the mains.
 Select menu option "MASTER" to set the desired light output.
 Refer to chapter HOW TO SETUP to learn how to set the other menu options.
B. Two or more units in master/slave setup:
 Connect the units together. Refer to the chapter "electrical installation" to learn how to do this.
 Select menu option "MASTER" to set the desired light output on the master (the first projector in the
DMX chain)
 Set all the other projectors in SLAVE mode
 The projectors will now follow the settings of the master projector so they all work synchronously.
C. Controlled by universal DMX-controller:
 Connect all units together. Refer to the chapter "Electrical installation for two or more units in DMX-
mode" to learn how to do this (don't forget to address all units properly!)
 Connect all units to the mains and turn on the DMX controller.
Since each unit has its own DMX-address, you can control them individually. Remember that each unit
BRITEQ
®
6/39
USER MANUAL
COB PAR56-100