Dispensing; Preparation For Dispensing; Priming - VITLAB piccolo 1 Mode D'emploi

7. Dispensing

7.1. Preparation for dispensing

1. Observe Operating Limitations and general safety regulations.
2. Push the intake tube into the intake valve as far as possible and cut
the lower end at an angle.
3. Screw the dispenser on to the reagent bottle and align it with the
bottle label.
Warning!
Avoid splashing of reagent!
4. Place a suitable vessel below the discharge tube.
5. The discharge tube must point away from the user at all times.

7.2. Priming

1. Place a suitable vessel below the discharge tube.
Warning!
Reagent may splash!
2. Gently push down the piston several times until air bubbles have
disappeared from the discharge tube.
26