Candy CDJ642KTT Manuel D'utilisation page 13

If the display flashes
setting
This means that:
• you have not placed a pan on the correct cooking zone or,
• the pan you're using is not suitable for induction cooking or,
• the pan is too small or not properly centred on the cooking zone.
No heating takes place unless there is a suitable pan on the cooking zone.
The display will automatically turn off after 1 minutes if no suitable pan is placed
on it.
When you have finished cooking
1. Touching the heating zone selection control that you wish to
switch off.
2. Turn the cooking zone off by touching the "-" and scrolling down to "0", or
holding the "+" and "-" button at the same time for 1 second, it will cut down to "0"
directly.
Make sure the power display shows "0", then shows "H".
3. Turn the whole cooktop off by touching the
ON/OFF control.
4. Beware of hot surfaces
'H' will show which cooking zone is hot to touch. It will disappear when the
surface has cooled down to a safe temperature. It can also be used as an
energy saving function if you want to heat further pans, use the hotplate
that is still hot.
alternately with the heat
and then
EN-12