Makita HW1200 Manuel D'instruction page 8

3. Attach the water hose connector to the inlet (with
the faucet marking) and then insert the coupling sleeve.
1
► 1. Coupling sleeve 2. Water hose connector 3. Inlet
on the high pressure washer
Connecting/disconnecting the nozzle
CAUTION:
Always lock the trigger when con-
necting/disconnecting the nozzle.
Insert the end of the nozzle into the slot on the trigger
gun and turn it in the direction of the arrow as shown in
the figure. To disconnect, turn the nozzle in the reverse
direction while pressing it toward the trigger gun.
1
► 1. Trigger gun 2. Slot 3. End of the nozzle
Some optional nozzles require the connecting joint
(optional accessory) to attach to the trigger gun. Attach
the connecting joint to the trigger gun in the same way
as the nozzle.
1
► 1. Nozzle 2. Connecting joint 3. Trigger gun
3
2
3
2
2 3
NOTE: The connecting joint is needed when using
the nozzles included with another model, HW112 or
HW121.
Connecting the foam nozzle
CAUTION:
Always lock the trigger when con-
necting/disconnecting the nozzle.
Prepare a detergent before using the foam nozzle.
1. Remove the nozzle from the tank by rotating the
nozzle counterclockwise. Attach the nozzle to the trig-
ger gun.
1
► 1. Nozzle 2. Trigger gun
2. Pour the detergent into the tank and install it to the
nozzle.
► 1. Tank
NOTICE:
Always use neutral detergent. Acidic or
alkaline detergent may damage the tank or nozzle.
OPERATION
WARNING:
Do not touch the water jet or
direct it toward yourself or others. The water jet is
dangerous and can hurt you or others.
WARNING:
When shooting the water jet,
never hold the object that you are cleaning or
place your hands and feet near the water jet.
8 ENGLISH
2
1