Makita HW1200 Manuel D'instruction page 10

3. Squeeze the trigger until the remaining water in
the high pressure washer is discharged.
Do not run the motor for longer than 1 minute.
4. Switch off the high pressure washer and unplug it
from the mains.
► 1. Power switch
5. Disconnect the high-pressure hose from the trig-
ger gun.
1
2
► 1. Trigger gun 2. High-pressure hose
1
10 ENGLISH
For the HW1200 only
Disconnect the high pressure hose from the high pres-
sure washer.
► 1. High pressure hose
For the HW1300 only
1. Reel the hose and fix the end of the hose.
1
► 1. Catch 2. Handle
2. Fold the handle into the reel arm while pulling the
handle to the direction of the arrow as shown in the
figure.
2
► 1. Handle 2. Reel arm
NOTICE:
To prevent the high-pressure hose from
being damaged, remove the remaining water in
the hose before storing.
1
1
2