Publicité
Les langues disponibles
Les langues disponibles
Stand, front (for turning plate) (accessory)
NOTE: Using the stand could increase the stability of the overall seat. The stand
could be used if the turning plate has been stabilised with the Seatfix connecti-
on and no footrest has been fitted.
First release the front locking screw in the tube support beneath the turning
plate (alongside the handle). (Fig. 4a)
Push the catch springs in at the rear of the guide tube and slide the stand's
guide tube as far as possible into the corresponding support beneath the turning
plate. (Fig. 4b)
Now re-tighten the locking screw beneath the turning plate. The screw should
hereby fit exactly into the safety bore hole of the guide tube.
To stabilise the stand you should now adjust the threaded rods of the stand to
the height of your vehicle's floor. Begin by releasing the locking ring at the top
end of the threaded rod and then set the correct height by turning the lower
rubber support of the threaded rod (contact with the vehicle's floor). Make sure
that the threaded rods are not over-extended – the turning plate and child's seat
should always lie flat on the vehicle's seat!
Now lock the threaded rod by twisting the upper locking ring upwards. This
prevents any accidental unscrewing of the threaded rods. (Fig. 4c)
Stabilising bow, rear (for turning plate) (accessory)
First release the rear locking screw on the tube support beneath the turning
plate. Slide the stabilising bow on the rounded rear side into the tube support
located there. (Fig 5a)
Now place the turning plate onto the seat so that the stabilising bow can be slid
in as far as possible between the vehicle's backrest and seat. (Fig. 5b)
Adjust the extension length of the stabilising bow to your vehicle. The child's
car seat has to have contact with the backrest of the vehicle's seat, when moun-
ted on the turning plate.
Turn the turning plate around carefully and tighten the locking screw correctly.
The screw should hereby fit exactly into one of the safety bore holes of the
stabilising bow's guide tube.
NOTE: The stabilising bow can be used from both sides (Fig. 5c), try out both
sides in your vehicle to find out which offers the most stability for the turning
plate.
Item code: 817
Item code: 819
7
Publicité
