Publicité
Les langues disponibles
Les langues disponibles
Turning plate with footrest adapter (accessory)
First clean the surfaces to be glued together. Place the child's car seat on its
back. Clean the plastic areas on the underside of the seat carefully by usual
means (e.g. water and washing-up liquid) until they are completely free from
grease.
Now remove the top two hook and loop strips (fleece) from the turning plate
and peel off the white adhesive covering. Stick the self-adhesive hook and loop
strip on the left and right of the cleaned underside of the seat so that lies flush
to the front edge (it is stuck up to the end at the rear (do not shorten). Press the
hook and loop strip firmly into place at all points and leave for 24 hours. After
24 hours the adhesive connection achieves its final strength. (Fig. 1a) The oppo-
site strips (hooks) remain on the turning plate.
Turning plate with footrest adapter (accessory)
To connect the RECARO Monza Nova 2 Reha to the turning plate, the adapter
plate first has to be installed on the seat. In order to do so, remove the four
screws (Torx T20) that are screwed into the seating shell of the RECARO Monza
Nova 2 Reha, the bottom of the seat.
Hold the adapter plate against the underside of the seat so that the countersunk
bores in the plate are on the bottom and the wider end of the adapter plate is
up against the rear end of the seat (Fig. 2a). Screw the plate onto the seat with
the supplied longer screws (Fig. 2b).
General safety instructions (only for the RECARO Monza Nova 2 Reha mo-
del) – except the
Please place your child into the RECARO Monza Nova 2 Reha seat slowly and
very carefully – especially when using the turning plate! If the seat is rotated
around 90° when the child is put in/taken out of the seat the backrest could
suddenly fall backwards if pressure is applied!
The back stabilisers (RECARO Monza Nova 2 Reha optional extra, Art. 816, Fig.
2d) prevent the backrest of the Monza Nova 2 model from accidentally folding
down. This could happen if the pressure on the catch lip on the backrest is too
high when a child is placed in the seat or if they suffer a sudden spasm when
using the turning plate in a rotated position. You will then hear a loud click, but
this does not indicate any damage. Press in the opposite direction to lock the
backrest into place. The catch lip can be removed if necessary.
4
version:
Item code: 820
Item code: 820/2
Publicité
