Technical Data - EINHELL TC-TS 820 Mode D'emploi D'origine

Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
The equipment is to be operated only with suita-
ble saw blades (saw blades made of HM or CV)
It is prohibited to use any type of HSS saw blade
and cutting-off wheel.
To use the equipment properly you must also
observe the safety information, the assembly
instructions and the operating instructions to be
found in this manual.
All persons who use and service the equipment
have to be acquainted with these operating
instructions and must be informed about the
equipment's potential hazards. It is also imperati-
ve to observe the accident prevention regulations
in force in your area. The same applies for the
general rules of health and safety at work.
The manufacturer will not be liable for any chan-
ges made to the equipment nor for any damage
resulting from such changes. Even when the
equipment is used as prescribed it is still impossi-
ble to eliminate certain residual risk factors.
The following hazards may arise in connection
with the machine's construction and design:
•
Contact with the saw blade in the uncovered
saw zone.
•
Reaching into the running saw blade (cut
injuries).
•
Kick-back of workpieces and parts of work-
pieces.
•
Saw blade fracturing.
•
Catapulting of faulty carbide tips from the saw
blade.
•
Damage to hearing if essential ear-muffs are
not used.
•
Harmful emissions of wood dust when used
in closed rooms.
Anl_TC_TS_820_SPK1.indb 19 Anl_TC_TS_820_SPK1.indb 19
GB

4. Technical data

AC motor ........................................ 230V ~ 50Hz
Power P .................................... 800 W S2 10 min
Idle speed n ...................................... 2950 min
0
Cutting-off wheel ............ Ø 200 x Ø 16 x 2.4 mm
Number of teeth ............................................. 24
Table size ..................................... 500 x 335 mm
Cutting height max. ......................... 45 mm / 90°
......................................................... 35 mm / 45°
Extractor socket ................................... Ø 36 mm
Weight ........................................... approx. 13 kg
Thickness of the splitter: ......................... 2.2 mm
Load factor:
A load factor of S2 10 min (intermittent periodic
duty) means that you may operate the motor
continuously at its nominal power level (800
W) for no longer than the time stipulated on the
specifi cations label (10 min). If you fail to observe
this time limit the motor will overheat. During the
OFF period the motor will cool again to its starting
temperature.
Danger!
Sound and vibration
Sound and vibration values were measured in
accordance with EN 61029.
Operation
L sound pressure level ..................... 96,6 dB(A)
pA
K uncertainty ............................................. 3 dB
pA
L sound power level ..................... 109,6 dB(A)
WA
K uncertainty ............................................. 3 dB
WA
The quoted values are emission values and not
necessarily reliable workplace values. Although
there is a correlation between emission and im-
mission levels it is impossible to draw any certain
conclusions as to the need for additional precau-
tions. Factors with a potential infl uence on the ac-
tual immission level at the workplace include the
duration of impact, the type of room, and other
sources of noise etc., e.g. the number of machi-
nes and other neighboring operations. Reliable
workplace values may also vary from country to
country. With this information the user should at
least be able to make a better assessment of the
dangers and risks involved.
- 19 -
-1
26.10.15 07:14 26.10.15 07:14