Maxspect JUMP Série Mode D'emploi page 4

4. Always unplug an appliance from an outlet when not
in use, before putting on or taking off parts, and
EN
before cleaning. Never yank cord to pull plug from
outlet. Grasp the plug and pull to disconnect.
5. Do not use an appliance for other than intended use.
The use of attachments not recommended or sold by
the appliance manufacturer may cause an unsafe
condition.
6. Do not install or store the appliances where it will be
exposed to the weather or to temperatures below
freezing.
7. Make sure an appliance mounted on a tank is securely
installed before operating it.
8. Read and observe all the important notices on the
appliance.
9. If an extension cord is necessary, a cord with a proper
rating should be used. A cord rated for less amperes
or watts than the appliance rating may overheat.
10. The power supply cords should be routed so that
they are not likely to be walked on or pinched by
items placed upon or against them. Never take hold
of the plug or cord if your hand is wet, and always
grasp the plug
disconnecting it.
11. The appliance is designed to be used in the water
ONLY, the entire body of the appliance must be
submersed in the water.
Installation
Switch the union couplings between 1 and 2 to fit
different size pipe or hose.
1
2
body when connecting
2
Operation Instruction
Controller Unit Introduction
Switching Between Modes
Pulsing Mode
Two
or
Stop for 10
minutes
Stop until exit
manually
Constant Speed Mode
Min Speed
Max Speed
Pulsing Mode One
Set a speed in Mode "1"(range 01-15);
1.
Set a duration in Mode "2"(range 01-20);
2.
For example, Mode "1"=05, Mode "2"=10(2.4s),
3.
the speed of pump will change sharply from 05 to
20 and back to 05 in 2.4s and repeat.
Speed
20
Set Speed
Duration Min: 01=0.6s, Max: 20=4.4s
Mode Indicator
Digital Display
Speed/Duration Indicator
Mode Switch Button
Button
Feed Mode Button
Button
Decrease Button
Increase Button
Constant Speed
Mode
Pulsing Mode
One
Stop for 20
minutes
Stop for 30
minutes
Speed
Time
Time