Ayce MJ10250VIIIC Traduction De La Notice Originale page 99

When sawing high, narrow work pieces, the auxiliary rip fence (aluminum) must be
mounted directly to rip fence.
Fig. 26
o. Installing the miter gauge (Fig. 27)
Groove Groove
Fig. 27
Rail
p. Adjusting the miter gauge (Fig. 28-29)
Fig. 28
Locking handle
Miter body
Pointer
• Fasten the auxiliary rip fence with the
2 square nuts (not supplied) and the
fastening knobs directly to the rip fence.
• Insert the guide rail of the miter gauge
into one of the guide grooves of the saw
table intended for this purpose.
• Loosen the locking handle in order to
allow the miter body to rotate freely.
Position the miter body at 90° so that
the positive detent secures it in
position. Tighten the locking handle
in order to hold the miter body securely
in position.
Fig. 29
Screw
q. To open the stand (Fig. 30-32)
Fig. 30
Release lever
196 | 197
• If the pointer requires adjustment,
loosen the screw that is located under
the pointer using a screwdriver. Adjust
the pointer to 90° on the scale, and
then tighten the adjusting screw firmly.
• In order to change the angle of the
miter gauge, loosen the locking handle
and the rotate the miter body to the
desired angle, as indicated on the
scale. Tighten the locking handle in
order to hold the miter body securely
in position.
• Grasp the grips on the stand and stand
the table as shown Fig. 30.
• Step on the release lever and pull the
grips toward you at the same time.
GB