Ayce MJ10250VIIIC Traduction De La Notice Originale page 106

dd. Mitering: 0° - 45° miter angle (Fig. 48)
This operation is the same as crosscutting, except that the miter gauge is locked at
an angle other than 90°.
Fig. 48
• Set the blade to a 0° bevel angle, and
tighten the blade bevel locking knob.
• Set the miter gauge to the desired miter
angle, and secure it in position by
tightening the miter gauge locking
handle.
• Hold the work piece firmly against the
face of the miter gauge throughout the
cutting operation.
MAINTENANCE
Always disconnect the device before performing any adjustment or
maintenance operation. If the supply cord is damaged, it must be
replaced by the manufacturer or its service agent in order to avoid
a hazard.
Disconnect from the power supply immediately if the supply cord is
damaged.
Cleaning
• Keep the ventilation slots of the machine clean to prevent overheating of
the engine.
• Regularly clean the machine housing with a soft cloth, preferably after each use.
• Keep the ventilation slots free from dust and dirt.
• If the dirt does not come off use a soft cloth moistened with soapy water.
• Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents
may damage the plastic parts.
! Make sure no water can reach the inside of the power tool!
WARNING
Lubrication
All motor bearings are permanently lubricated at the factory, and do not require
any additional lubrication. Use graphite or silicone to lubricate all mechanical parts
of the table saw where a pivot or threaded rod is present. Dry lubricants do not hold
saw dust like oil or grease.
Transportation
When transporting the machine use only transportation devices and do never use
guards for handling, lifting or transportation.
During transportation the upper part of the saw blade should be covered;
for example by the guard.
Storing
Store the machine, operating instructions and where necessary the accessories in
the original packaging. In this way you will always have all the information and parts
ready to hand. Pack the device well or use the original packaging in order to avoid
transit damage. Always keep the machine in dry place.
210 | 211
GB