Ayce MJ10250VIIIC Traduction De La Notice Originale page 104

x. Ripping (Fig. 42)
Fig. 42
• Remove the miter gauge, and secure
the rip fence to the table.
• Raise the blade until it is approximately
1/8" (3.2 mm) above the top of the work
piece.
• Place the work piece flat on the table
and against the fence so that the larger
portion of the work piece is between
the blade and the fence. Keep the work
piece approximately 1" (2.5 cm) away
from the blade.
• Turn the saw ON, and wait for the blade
to reach full speed.
• Slowly feed the work piece into the
blade by pushing forward on the section
of the work piece that will pass between
the blade and the fence.
• Do not place your thumbs on the table
top. Always hold the work piece while
the blade is turning. Do not let go of it
in order to reach for the push stick.
When both thumbs touch the front edge
of the table, complete the cut using a
push stick.
• Always use the push stick when
performing ripping operations.
• Continue to push the work piece with
the push stick until it passes the blade
guard and clears the rear of the table.
• Do not pull the work piece backward
while the blade is turning. Turn the
switch OFF, and unplug the power cord.
Wait until the blade comes to a complete
stop and slide the work piece out.
y. Bevel ripping (Fig. 43)
Fig. 43 Fig. 40
! The work piece and the fence must be on the right side of the blade
when cutting.
WARNING
z. Ripping small pieces
! Avoid injury caused by contact with the blade. Do not use this saw to
make through-cuts that are narrower than 1/2" (13 mm).
WARNING
• It is not safe to rip small pieces. Instead, rip a larger piece in order to obtain the
size of the desired piece.
• When ripping a small work piece, it is not safe to place the hand between the blade
and the rip fence. Use one or more push sticks to push the work piece completely
past the blade.
206 | 207
• Bevel ripping is the same as ripping,
except that the blade bevel angle is set
to an angle other than "0".
GB