Ayce MJ10250VIIIC Traduction De La Notice Originale page 98

l. To assemble the rear extension table (Fig. 22-23)
Fig. 22
Fig. 23
• Sliding the tubes into the two holes at
the back of the main table.
• Fix the screw M4 x 10 into the hole at
the end of extension tube located near
the sliding table to prevent the side
table from being pulled out too far.
• You can lock at the desired position with
the two locking knobs at the bottom of
the main table.
m. To assembly the rip fence (Fig. 24)
Fig. 24
Rear holding
clamp
Handle
n. To assembly the auxiliary rip fence (Fig. 25-26)
When cutting narrow work pieces and for bevel cuts, the auxiliary rip fence
(aluminum) must be mounted to the rip fence.
The auxiliary rip fence can be mounted left or right side of the rip fence.
Fig. 25
194 | 195
• Lift the rip fence handle until the rear
holding clamp is fully extended.
• Place the rip fence on the saw table,
lowering the rear of the fence onto the
table first.
• Push down the rip fence handle in order
to lock the rip fence in position.
• Insert the profile rail into the groove
on the short side of the auxiliary rip
fence.
• Position the profile rail in front of the
rip fence in such a manner that the
holes of both parts are in alignment.
• Insert the fastening knobs through the
lateral holes in the rip fence and tighten
them.
GB