Grounding Instructions - EHEIM 1046 Mode D'emploi

i ) Read and observe all the important notices on the appliance.
j ) If an extension cord is necessary, a cord with a proper rating should be
used. A cord rated for less amperes or watts than the appliance rating may
overheat. Care should be taken to arrange the cord so that it will not be
tripped over or pulled.
k) This appliance has a polarized plug (one blade is wider than the other).
As a safety feature, this plug will fit in a polarized outlet only one way. If
the plug does not fit fully in the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician.
Never use with an extension cord unless plug can be fully inserted. Do not
attempt to defeat this safety feature.
xception: This instruction may be omitted for an appliance that is not
provided with a polarized attachment plug.
"S VE THESE INSTRUCTIONS".
l )
W RNING! Risk of electric shock.
This pump is supplied with a grounding conductor and grounding-type attach-
ment plug. To reduce the risk of electric shock, be certain that it is connected
only to a properly grounded, grounding-type receptacle, in a circuit protected
by a ground fault circuit interrupter.

GROUNDING INSTRUCTIONS

This appliance should be grounded to minimize the possibility of electric
shock. This appliance is equipped with an electric cord having an equipment
grounding conductor and a grounding-type plug. The plug must be plugged
into an outlet that is properly installed and grounded in accordance with all
appropriate codes and ordinances.
This appliance is for use on a nominal 120 V circuit, and has a grounding
plug that looks like the plug illustrated in Sketch . A temporary adapter which
looks like the adapter illustrated in Sketches B and C, may be used to con-
nect this plug to a two pole receptacle as shown in Sketch B if a properly
grounded outlet ist not available. The temporary adapter should be used only
until a properly grounded outlet can be installed by a qualified electrician. The
green colored rigid ear (lug, etc.) extending from the adapter must be fastened
to a permanent ground such as a properly grounded outlet box.
GROUNDING PIN
(C)
GROUNDING MEANS
( )
ADAPTER
COVER OF
GROUNDED
OUTLET BOX
GROUNDING PIN
(B)
(D)