Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

11. Mic volume control
13. Echo control
15. Bass control
17. Left input (L) and right input (R)
19. MP3/Ipod input
21. Signal reception LED
23. VHF transmission ON LED
25. Fuse T6A
27.12VDC input (+) positive terminal
29. Power ON LED
© Copyright Lotronic 2013
12. Voice control: Press in to activate the
function. Press out to deactivate
14. Treble control
16. Volume
18. Left output (L) and right output (R)
20. Antenna connector
22. Wireless Mic volume
24. VHF switch: Depress for ON, press out
for OFF
26. 12DC input negative (-) terminal
28. Charge LED: RED during charge,
Green when battery is full
30. Power switch
POWER SUPPLY or BATTERY OPERATION
1.
Prior to using the nit for the first time, you have to charge the built in battery for 10
hours. Plug one end of the mains led into the AC input on the rear side of the box
and the other end into a suitable mains outlet.. The charge indicator must light
steadily in red. When it turns green, the battery has been fully charged.
2.
If you don't use the system for a longer period of time, recharge the battery once
every 6 months.
NOTE: Switch the system OFF after use.

PLAYING CDs

1. Set the ON/OFF switch (30) to ON.
2. Press the OPEN/CLOSE button (2) and insert a CD. Close the tray and
press the PLAY button (3).
3. If you insert a CD with MP3/WMA files, the play starts automatically.
KARAOKE & VOCALS
1. Insert a karaoke disk or connect a music signal to the RCA input (17) or the
iPod input (19).
2. Plug the stereo jack of your microphone to the MIC1 (9) or MIC2 (10) input.
3. If you want to use the wireless mic, enable the VHF function by depressing
the button (24). The VHF power LED (23) should light up.
4. Adjust the MIC VOL/VHF VOL/ECHO/MASTER VOL to your convenience.
5. If you want the volume of the music to decrease while you are talking into
the microphone, enable the voice control function via the button (12).
NOTE: Switch the wireless mic off when not in use.
Remove the battery from the mic after use.
SPECIFICATIONS
Wireless VHF mic
-
Noise sensitivity : 12uV (S/B=30dB)
-
Selection : 20dB (double)
-
Distortion : <1,5%
-
S/N ratio : 60dB
Mic input sensitivity: 30mV/600 Ohms
S/N ratio CD/MP3: >80dB
Output level CD/MP3: 1V dc
Speakers: 2x 8" woofers 2x50W & 2x 3" tweeters 2x15W
Port9CD-VHF
Copyright Lotronic 2013

Publicité

Table des Matières
loading

Table des Matières