Publicité
Les langues disponibles
Les langues disponibles
High Performance Air Purifi er
Before inserting the batteries, check
whether the contacts in the remote con-
trol and on the batteries are clean, and
clean them if necessary.
1. Slide the battery compartment cover
in the direction of the arrow and take
it off.
2. Take out used batteries and insert two
new ones (1.5 V; AAA). Pay attention
to the correct polarity (+ / –).
3. Insert the battery compartment cover
in the remote control and slide it shut.
You must hear and feel it engage.
Replace the batteries if the power of the
remote control starts to wane.
Please Note!
The device must have clearance of at
least 30 cm above it and to all sides
and be placed on a dry, even, solid
and moisture-resistant surface.
Before use, ensure that the fi lters are
correctly fi tted.
Only connect the device to a plug
socket that is properly installed and
matches the technical data of the
device. The plug socket must also be
readily accessible after connection so
that the connection to the mains can
quickly be isolated.
Do not operate the device unsuper-
vised so that you can intervene imme-
diately if there are any faults.
1. Position the device at the required
location.
For effi cient operation we recom-
mend closing the windows and
doors of the room.
2. Fully unwind the connecting cable
and connect it to an easily accessible
plug socket. You will hear a beep. All
elements on the touch display ( ) light
up and go out, with the exception of
the
fi eld (
panel (
). The device is in standby
mode.
3. Touch the
fi eld to switch on
the device. The touch display lights
up permanently and the device starts
to operate.
The function
the ionising function
preset.
4. Adjust the settings of the device to
suit your individual needs (see the
"Functional Overview and Operating
Elements" chapter).
5. If the device is no longer going to
be used, switch off the device via the
fi eld and pull the mains plug
out of the plug socket.
Please Note!
The fi lters cannot and must not be
cleaned.
Do not use any sharp or abrasive
cleaning agents or cleaning pads to
clean the device. They may damage
the surfaces.
•
Make sure that the device is not con-
nected to the mains power.
•
Wipe down the device with a soft,
damp cloth.
•
Store the device in a clean, dry place
so that it is protected and is out of the
reach of children and animals when it
is not in use.
EN
) on the control
and
(
) are
Publicité
