Antares ANTARION G6+ CONNECT Manuel D'installation page 29

1. Connections between the antenna cable from LNB (cable no. 1) and the satellite receiver cable
from the antenna input (cable no. 2) are made using the F connectors attached to the end of the
cables.
2. The connection between the motor control cable (cable no. 3) and the motor cable pulled from
the satellite receiver motor input (cable no. 4) is made using the connectors at the end of the
cables.
3. The connections of the motor cables (no. 3 and no. 4) are made via connectors.
4.
The cover of the fitting attached to the cable is placed in its groove to tighten the plastic bolt.
5. It is necessary to make a connection between the control box (Loop OUT) and the demodulator
(TNTSAT, FRANSAT or other) via a coaxial cable. Then make the connection between the
demodulator (TNTSAT or other) and the TV via an HDMI cable, SCART socket or RCA cable.
6. The control box (this power supply must be drawn directly from the battery) and the
demodulator are powered by 12-24VDC. The + after contact "CONTACT" must be correctly
connected and this to guarantee safety.
English
9