The Distributor Will Not Be Liable In The Following Cases - Antares ANTARION G6+ CONNECT Manuel D'installation

Automatic Antenna

Engine unit linked to the gearbox

Aluminium mounting plate (optional)

Rubber cup holder

Operation manual for the automatic reception system

STARTING UP
Starting the antenna
First of all, make sure that the cables between the antenna, the control box and the control panel
are well positioned.
.
Press the" " button in the middle of the control panel screen to start the antenna. A light
comes on and the antenna starts searching: the antenna opens and begins its search.
The light flashes slowly under the selected satellite. When the satellite is found, the antenna
refines its search with small movements to optimize the signal gain. The light then flashes more
quickly. Then the antenna is definitively positioned and stops. The light no longer flashes.
When the satellite is found, the signal becomes available. You can then turn on your demodulator
(TNTSAT, FRANSAT,...) and your TV.
To select another satellite for antennas with remote mini-panels, use the up or down arrows. The
light will move at the same time. It will flash during the search time and remain on when the
antenna has found the new satellite.
Closing the antenna:
Press the" " button in the middle of the control panel screen to close the antenna. The
antenna will close automatically. The light will go out when the antenna is completely closed.

The distributor will not be liable in the following cases:

Damage caused by natural disasters such as fire, earthquake and lightning, events and
accidents that could involve third parties, as well as any incidents related to misuse or
non-compliance with the recommendations.
2. damage caused by operating errors (loss of gain or interruption, modification or deletion
of data, etc.):
3. Damage caused by negligence of the instructions presented in this manual.
4