Husqvarna K 770 Manuel D'utilisation page 31

To adjust the tension of the recoil
spring
1. Pull out the starter rope.
2. Hold the starter rope pulley (A) with your thumb.
B
A
C
3. Put the starter rope in the notch (B) and wind it up
around the metal sleeve (C).
4. Pull out the starter rope (A).
A
5. Put your thumb on the starter pulley (B) to keep the
starter rope pulled out.
1447 - 004 - 04.05.2021
B
6. Release the starter rope from the notch.
7. Remove your thumb to release the starter pulley (A)
and let the starter rope (B) wind up on the pulley.
8. Pull out the starter rope fully to do a check that the
recoil spring is not at its end position. Make sure that
the starter pulley can be turned half a turn or more
before the recoil spring stops the movements.
To remove the spring assembly
WARNING:
when you remove the spring assembly.
There is a risk for eye injury, especially if a
spring is broken.
1. Remove the 2 screws on the spring assembly.
2. Push the 2 brackets on the snap locks with a
screwdriver.
To clean the spring assembly
CAUTION:
from the assembly.
1. Blow the spring with compressed air until it is clean.
B
A
Always use eye protection
Do not remove the spring
31