Early Working Procedures; Operation Start Procedure - Kamikaze VOLPI KVS 2000 Manuel D'utilisation

ELECTRONIC SAW
• Check that the spring of the chain cover works properly
• Insert the battery into the special location of the chainsaw until it clicks,
checking that it is locked.

13. EARLY WORKING PROCEDURES

Wear suitable gloves and clothing before using this tool. Check the tool
before working and verify the correct operation of the switch.
The chain must stop when the trigger is released. Do not use
the chainsaw if the switch fails. Check that the battery voltage
matches the tool voltage.
The electric motor stops when the trigger is released, but the
chain will continue moving by inertia for a few seconds. Do not
touch the chain while it is moving to avoid the risk of injury or
wounds.
• Hold the saw firmly with both hands.
• Make sure that the chain and bar are not in contact with any object.
• Press the safety button with your thumb to unlock the trigger.
• Press the trigger all the way down, the machine starts.
• Do not exceed the cutting dimensions to protect the saw and battery from
possible damages.
• Do not cut branches larger than those indicated in the technical specifications.
• Release the trigger if the chain is blocked, the engine stops.
www.kamikazevolpi.com
86