ELECTRONIC SAW
4.4 CORRECT USE OF THE BATTERY CHARGER
•
Use this battery charger only with rechargeable batteries. Otherwise it
could cause fire and explosions. Use only the original battery charger.
•
Always check the charger, the cable and the plug before each use. If
damaged, ask to the service center for repair or replacement. Do not
use damaged chargers. Do not try to repair damaged battery chargers to
keep the tool safe.
•
Check that the voltage of the charger matches the one of the battery,
otherwise it may cause personal injury.
•
Keep the charger clean, away from humid environments and rain. Do
not use the charger outdoors: dirt and water may cause damages to the
charger and personal injury.
•
The charger is designed for use with original batteries, otherwise it may
cause risk of fire or explosions.
•
Do not use damaged chargers to reduce the risk of injury.
•
Do not use the charger on flammable surfaces (eg. paper).
•
The battery is not fully charged on first use, it must be charged for 3/4
hours before first use.
•
The normal charging time is 4/6 hours (charging time for 3 fully discharged
batteries), do not charge the battery for too long to avoid damaging it.
•
The charger has three outputs, it is possible to charge up to 3 batteries
at the same time. The charging time is proportional to the number of
batteries connected and to the state of their charge. Supervise the
charging time by the LED indicator (red light in charge, green light end
of charge).
4.5 ATTENTION (RESIDUAL RISKS)
Use the tool carefully in order to avoid the following risks:
•
Cuts and wounds caused by sharp edges
•
Use for prolonged times or in incorrect positions can cause damage to
your body in the long term.
www.kamikazevolpi.com
78