Battery Charging Procedure; Charging The Battery - Kamikaze VOLPI KVS 2000 Manuel D'utilisation

ELECTRONIC SAW
10. BATTERY CHARGING
Do not expose the battery to extreme conditions such as excessive
temperatures or shocks. Injury can be caused by the loss of battery
material.
Disconnect the battery from the tool before start charging.
Make sure the battery is dry and clean before start charging.
• Make sure the battery is fully charged before using it for the first time.
• The battery is not fully charged when purchased, charge it for 3-4 hours
before using it for the first time.
• Before charging the battery, check the remaining charge on the display.
• The battery must be replaced if its life start being insufficient. Use only the
original batteries supplied by the manufacturer.
• Respect the safety and environmental protection guidelines during each
phase.

10.1 BATTERY CHARGING PROCEDURE

• Recharge indoor, temperature between + 10 ° C and 22 ° C.
• The three-way battery charger allows to recharge the two batteries
supplied at the same time.
• Make sure that the characteristics of the charger and the battery are
aligned before starting the recharge.
• The red LED on the charger indicates that the battery is charging, the
green LED indicates that it is fully charged. The approximate charging
time is 4 to 6 hours, do not keep the batteries connected longer than
necessary as they may be damaged.
• The charger has three ways, it is possible to charge up to 3 batteries at the
same time. The charging time is proportional to the number of batteries
connected and to the state of their charge. Monitor the charging time by
the LED indicator (red light in charge, green light end of charge).
• Disconnect the battery charger connectors from the batteries once the
charge is complete.
• Make sure the battery is charged at least every 3 months when not in use.
Do not store the machine with the battery connected.
www.kamikazevolpi.com
84