Troubleshooting Guide - DeWalt D25614 Guide D'utilisation

For assistance with your product, visit our website at www.dewalt.com for a list of service centers, or call D
1-800-4-D WALT (1-800-433-9258).
e
PROBlEM
Tool will not start.
Reduced Power
The bit does not rotate.
The bit cannot be released.
The yellow or red service indicator
lights are on or flashing.

TROUBLESHOOTING GUIDE

BE sURE TO FOllOW sAFETY RUlEs AnD insTRUCTiOns
POssiBlE CAUsE
The extension cord and/or plug is defective.
Internal componets too hot.
Brushes worn out.
The extension cord is too long and/or its gauge
is inadequate.
The speed dial is set to a lower setting.
The voltage provided by the electric supply
is inadequate.
The mode selector dial is not correctly engaged,
or is set to "Hammering Only" or is set to
position .
The chuck is not pulled back fully.
The carbon brushes are nearly worn or the time
for service has been reached.
sOlUTiOn
Have the extension cord and/or plug checked by a qualified
electrician and replaced if necessary.
Allow tool to cool down.
Have brushes replaced by an authorized D
Use an extension cord of an approved length and/or of
adequate gauge.
Rotate the speed dial to a higher setting suitable for
the application.
Connect the hammer to an adequate electric supply.
Rotate the mode selector dial to "Rotary Hammering". Refer to
Operation Modes.
Pull the chuck back as far as it will go and remove the bit. Refer
to Inserting and Removing SDS MAX Bits.
Have tool service performed by an authorized D
center. Refer to E-Clutch® and Service Indicator LEDs.
English
WALT at
e
WALT service center.
e
WALT service
e
9