Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
10. ATTACHING THE CYLINDER WIRE RETAINER
Parts Required:
1
x
LP Gas Cylinder Wire Retainer (#33)
Installation:
•
Remove the R-clip from LP gas cylinder wire retainer. Attach the LP gas
cylinder wire retainer to the right legs. Use R-clip to secure wire retainer
in place.
11. SECURING THE CYLINDER SUPPORT BRACKET
Parts Required:
1
x
LP Gas Cylinder Support Bracket (#32)
Screw (#A)
3
x
Washer (#B)
3
x
3
x
Locking Washer (#C)
Installation:
•
Secure the LP gas cylinder support bracket to the cart bottom shelf
using three screws, locking washers, and washers.
12. ATTACHING THE HOSE RETAINER
Installation:
•
Attach Hose Retainer to the side burner panel with the pre-installed screw.
13. INSTALLING THE LID HANDLE
Parts Required:
2
x
Lid Handle (#9)
4
x
Lid Handle Bezel (#10)
Installation:
•
Remove the pre-installed screws from the Lid Handle. From inside the
barrel lid, insert one screw protrude to the outside. Add a Bezel on
the screw. Then hand-tighten the screw (from the inside) into the Lid
Handle. Repeat for other side.
14. SECURING THE FRONT SHELF BRACKETS
Parts Required:
Front Shelf Bracket / Left (#36)
1
x
1
x
Front Shelf Bracket / Right (#37)
4
x
Screw (#A)
4
x
Washer (#B)
4
x
Locking Washer (#C)
Installation:
•
Attach one Front Shelf Bracket to the front of the Grill Barrel by using
two screws. Install each screw half-way, then tighten completely when
all two screws are mounted and aligned properly. Repeat the same
installation for the other Front Shelf Bracket.
9
10
11
Ax3 Bx3 Cx3
12
SECURING CYLINDER SUPPORT BRACKET
Secure the LP gas cylinder support bracket to
the cart bottom shelf using three screws,
locking washers, and washers.
13
14
33
ATTACHING CYLINDER WIRE RETAINER
Remove the R-clip from LP gas cylind
wire retainer.
Attach the LP gas cylinder wire reta
to the right legs.
32
Use R-clip to secure wire retainer i
place.
9
9
10
10
36
37
ACB
ATTA
Atta
burn
scre
Publicité
Chapitres
Table des Matières
