Securing Cart Front/Back Panel; Mounting Main Barrel To The Cart; Securing Cart Panel To The Grill; Securing The Cart Bars - Navigator PIT BOSS PB1230G Guide De Montage

• Attach the large Wheel to the Support Leg by inserting the Wheel Axle
Pin through the Wheel, Support Leg hole, then secure using the Wheel
Cotter Pin. Repeat installation for other Wheel on the same side.

6. SECURING CART FRONT/BACK PANEL

Parts Required:
1 x Cart Back Panel (#28)
1 x Cart Front Panel (#29)
Screw (#D)
8 x
Installation:
• Install Cart Back Panel to the front two Support Legs of the unit. Secure
using two screws on each side. Ensure the flat side of the Support Plate
is facing outwards. Repeat the same installation to Cart Front Panel
plate to the other Support Legs.

7. MOUNTING MAIN BARREL TO THE CART

Parts Required:
1 x Main Barrel (#11)
12 x Screw (#A)
12 x Washer (#B)
12 x Locking Washer (#C)
Installation:
• Prepare the Main Barrel to be mounted to the Cart. Position the Cart
next to the Main Barrel, with both facing the same direction. Lock the
Caster Wheels on the Cart. Using a second person, prepare to lift the
Main Barrel onto the Cart. With one person lifting from the hopper side,
and the other person lifting from the opposing barrel end, carefully lift
the Main Barrel, and slowly lower onto the Cart.
• Next, open the Main Barrel lid. Adjust the rotation as needed to align
the screw holes of the Main Barrel to the Cart. Once placed, secure each
leg to the Main Barrel using three screws, washers, and locking washers.

8. SECURING CART PANEL TO THE GRILL

Parts Required:
Screw (#E)
4 x
Installation:
• Secure Cart Front / Back Panel to Barrel using four screws.

9. SECURING THE CART BARS

Parts Required:
2 x Cart Bar A (#34)
Cart Bar B (#35)
1 x
Installation:
• Secure the Cart Bar A and Cart Bar B to each support leg using the
pre-installed screw, locking washer, and washer.
6A
28
29
7
11
8
E
E
E
9
35
34
34
SECURING THE CART BAR
Secure the cart bar A and cart bar B
to each support leg using the
A
C
B
E
8