Husqvarna WDC 220 Manuel D'utilisation page 13

To install the tube holder
1. Move the tube holder vertically on the extension
tube.
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
To start the product
Before the product is used, make sure that the
frequency and voltage shown on the rating plate is the
same as the mains voltage.
1. Make sure that the main switch is in position "0".
(Fig. 10)
2. Do a check that correct filters are in position in the
product.
3. Put the hose into the vacuum inlet at the front of the
product. Push the hose forward until it is installed
tightly in position in the vacuum inlet. (Fig. 16)
4. Connect the two extension tubes with the handle.
Twist the extension tubes to make sure that they are
correctly in position.
5. Attach a nozzle to the extension tube. Select the
nozzle after the type of material that is to be cleaned.
6. Connect the plug into the mains.
7. Put the main switch into position "I" to start the
product. (Fig. 17)
To stop the product
1. Put the main switch into position "0" to stop the
product.
2. Disconnect the plug from the mains. (Fig. 10)
To use the blow function
1. Put the hose in the opening on the rear of the
product. (Fig. 21)
2. Connect the plug into the mains.
3. Put the main switch to the "I" position. (Fig. 17)
4. Adjust the blow power on the handle or by the main
switch*. *Only on some models. (Fig. 22)
To use the power tool socket*
*Only on some models.
CAUTION: Follow the operating instructions
and safety instructions for appliances
connected to the power tool socket.
562 - 004 - 20.03.2019
2. Use a screwdriver to install the tube holder on
correct height of the extension tube. (Fig. 19)
3. Park the extension tube at the holders on the rear of
the product. (Fig. 20)
Operation
Note: The maximum power consumption of the
connected tool is told in section
16 .
1. Make sure that the switch on the power tool is in
position "0". (Fig. 23)
2. Disconnect the handle from the hose. Press the
hatches on the hose end (A) and pull out the handle
(B). (Fig. 24)
3. Connect the power tool adaptor. (Fig. 25)
4. Adjust the suction power on the power tool adaptor
or by the main switch*. *Only on some models. (Fig.
26)
5. Connect the hose to the vacuum inlet of the product
and to the power tool. Connect the cable of the
power tool to the electrical connection of the product.
(Fig. 27)
6. Make sure that the switch on the power tool is in
position "0". (Fig. 23)
7. Turn the main switch on the product to the power
tool position (A).
8. Put the switch of the power tool to "I" (B). (Fig. 28)
Note: You can start and stop the product with the
main switch on the product (A) or on the power tool
(B).
To clean liquid
Note: The product has a float system that stops the
airflow through the product at the maximum liquid level.
CAUTION: Do not clean liquid without the
float system in position.
1. Make sure that the filter and the filter tension (the
float system) is in position, see
on page 15 . Remove the filter bag if it is installed.
2. Use the floor nozzle to clean liquid.
3. At the maximum liquid level, a noticeable change of
the motor sound is heard. The suction power
decreases.
4. Stop the product, see
13 .
5. Empty the dirt container, see
container after liquid pick up on page 14 .
Technical data on page
To replace the filter
To stop the product on page
To empty the dirt
13