Husqvarna WDC 220 Manuel D'utilisation page 10

For Dust Class L products,
•
WDC 325L, the following
applies:
Use the product to clean
•
dry, non-flammable dust and
liquids, dangerous dusts
1)
with OEL
Dust Class L (IEC
60335-2-69). The dust with
this class has OEL
3
> 1mg/m
Products with the Dust
•
Class L, has a tested filter
material. The maximum
degree of permeability is
1%. There is no special
requirement for disposal.
Note: Refer to local laws. They can regulate the age of
the operator.
Safety for double-insulated products
WARNING: Only use the product as given in
this manual and only with the manufacturer's
recommended accessories.
WARNING: Only applicable to UK: Read
these important instructions.These
instructions have been prepared with safety
and efficiency paramount. The operator
must be trained by an approved instructor
and must understand these instructions for
operation. The operator must know all the
related regulations and legislation in force at
the time of operation.
WARNING: Before you connect the product:
Make sure that the mains voltage and the
mains frequency of the power supply match
the data on the rating plate of the wet/dry
vacuum cleaner.
WARNING: This product has double
insulation. Use only Husqvarna replacement
parts. See instructions on how to do service
on double-insulated products.
10
value > 1mg/m
1)
values
.
WARNING: The product has a special cord.
If the cord is damaged, it must be replaced
by a cord of the same type. This is available
at approved service centers and dealers and
must be installed by approved personnel.
WARNING: Service on a double-insulated
product requires knowledge of the system.
In a double-insulated products, two systems
of insulation are provided instead of
3
.
grounding. No grounding means is provided
on a double-insulated product, nor should a
mean for grounding be added to the
appliance. Service must be done only by
approved service personnel. Replacement
parts for a double-insulated product must be
identical to the parts they replace. A double-
insulated product is marked with the words
"DOUBLE INSULATION" or "DOUBLE
INSULATED." A symbol may also be used
on the product.
Electrical safety
• It is recommended that the vacuum-cleaner should
be connected via a residual current circuit breaker.
• Arrange the electrical parts (sockets, plugs and
couplings) and lay down the extension lead so that
the protection class is maintained.
• Connectors and couplings of power supply cords
and extension leads must be watertight.
Extension lead
• As an extension lead, only use the version specified
by the manufacturer or one of a higher quality.
• When using an extension lead, check the minimum
cross-sections of the cable:
Cable length
< 20 m
20-50 m
WARNING: The upper
section of the vacuum-
cleaner contains live
components. Contact with
live components leads to
serious or even fatal
injuries.
Cross section
< 16 A < 25 A
2
1.5 mm 2.5 mm
2
2.5 mm 4.0 mm
562 - 004 - 20.03.2019
2
2