Husqvarna DS150 Manuel D'utilisation page 7

a) For DS150: Drill the hole at a distance (A) of 293
mm/11.5 in. from the center of the hole that you
will drill.
A
1341 - 003 - 27.10.2021
b) For DS250: Drill the hole at a distance (A) of 300
mm/11.8 in. from the center of the hole that you
will drill.
A
Note:
The distance is for drill motor DM220
installed on the quick mounting plate. If the drill
motor is installed with a collar, the distance is
320 mm/12.6 in.
2. Attach the bottom plate with an expander bolt.
3. Make sure that the expander bolt is tightened
correctly.
7