Installation - Husqvarna DS150 Manuel D'utilisation

• Attach the wheel kit to the bracket at the rear end of
the bottom plate and tighten the screws.
To attach a drill motor (DS150)
WARNING:
from the power supply.
1. Remove the drill bit from the drill motor.
2. Lock the carriage lock.
3. Put the drill spindle through the collar in the drill
motor carriage.
4. Tighten the screw with the feed lever.
Procedures for installation
There are 3 procedures that can be used to install the
product before a drill operation:
• With an expander bolt.
• With a vacuum plate.
• With an all thread rod, a washer and a locknut.
6
Disconnect the drill motor

Installation

To attach a drill motor (DS250)
WARNING:
from the power supply.
1. Remove the drill bit from the drill motor.
2. Lock the carriage lock.
3. Attach the drill motor in the lock clamp on the drill
motor carriage.
4. Push the drill motor fully down to the bottom of the
lock clamp (A).
C
A
5. Tighten the lock clamp with the lever (B).
6. If you install the drill motor DM240, also tighten the
lock screw (C).
Note:
The lock screw is only used together with
the drill motor DM240.
To install the product with an expander bolt
WARNING:
ceiling or a wall puts much strain on the
surface. For operation in ceilings and walls,
use only an expander bolt or anchor screw
that is applicable for the strain.
1. Drill a hole for the expander bolt.
Disconnect the drill motor
B
To install the product to a
1341 - 003 - 27.10.2021