Kerbl 29923 Mode D'emploi page 22

4.7 Communication of serial interface (optional)
The communication of serial interface contains four modes.
A) Continuous transfer: don't receive orders and transfer the data every 0.3 seconds in the weighing
mode.
B) Response transfer: the pc transfers the orders of inquirying and zeroing, the scale will response and
transfer the corresponding datas.
C) Stable transfer: don't receive the orders and transfer the data once the weighing is stable.
A) Print mode: the mode is same as the mode 3) but the transferring format is different. It applies to
printer connection. The detailed setting refers to 6.3 communication interface setting.
5.0 ALARMING FUNCTION
5.1 Over load alarming
When the load on the platform is over 9 D. the beep will sound and the display will show
you must remove the load from platform immediately.
5.2 Low load alarming:
If there is problem in load cell, the beep will sound and the display will show .
5.3 Counting alarm:
In counting status, when the scale is in minus number it will display and when the number
is over 1000000, it will display .
5.4 Low battery alarming:
When the light of low battery voltage appears, you're requested to recharge the scale over 12 hours.
When the scale is in recharging, the mark light will be in flashing. The mark light will disappear after
recharge have finished.
5.5 Charge indication:
When the scale was charging, the charge light is red. It will turn green when finishing the charge.
22