Setting Up And Connecting The Cooling Device; Changing The Door Hinge - Dometic GROUP WAECO CoolMatic MDC065 Notice D'utilisation

Setting up and connecting the cooling device

6 Setting up and connecting the cooling
device
6.1 Setting up the cooling device
The device is designed for ambient temperatures between +16 °C and
+32 °C. In continuous operation, the air humidity may not exceed 90 %.
Set up the cooling device in a dry, sheltered place. Avoid placing it near heat
sources such as radiators, gas ovens or hot water pipes. Do not let it stand
in the direct, strong sunlight.
The cooling device must be positioned so that heated air can dissipate easily.
Therefore make sure there is adequate ventilation (fig. 2, page 4).
No. in
fig. 2, Explanation
page 4
1 Hot waste air
2 Cold intake air
6.2 Sealing system
The cooling device has a locking mechanism to protect it during transport.
The following settings are possible:
 Position 1 (transport lock): (fig. 3 1, page 4) The door is locked and
secured. To open the door, turn the bolt to position 2.
 Position 2 (releasing transport lock): (fig. 3 2, page 4) The door can
be opened.
 Position 3 (VENT position): (fig. 3 3, page 4) The door is slightly open,
but fixed in position. Use this position, for example, if you are not going to
use the device for a long time.
6.3

Changing the door hinge

You can also change the hinge of the door, so that it opens to the left rather
than the right.
To change the door hinge, proceed as follows (fig. 4, page 5):
➤ Remove the upper door hinge (fig. 4 1, page 5).
➤ Carefully lift out the door.
➤ Remove the threaded pins (fig. 4 2, page 5).
➤ Pull the locking hook (fig. 4 3, page 5) off the rod.
28
MDC065(K), MDC090(K)
EN