Before Start-Up - Matrix DWS 710 Notice Originale

doctor and the manufacturer of the medical
implant before using the power tool.
5. Tool description and scope of
delivery
5.1 Tool description (B1)
The tool description refers to the illustration at
the beginning of this instruction manual.
1. Handle surface
2. Main handle
3. On/off switch
4. Adapter with connecting nut
5. Power cord
6. Adjustment wheel for speed pre-selection
7. Ventilation opening
8. Flexible grinding head
9. Grinding plate
10. Brush edge
11. Extraction hose
12. Hose adapter
13. Abrasive sheet
5.2 Scope of delivery (B1)
1 drywall sander
1 extraction hose (11)
2 hose adaptor (12)
6 abrasive sheets (13) (different grain sizes)

6. Before start-up

6.1 unpacking
1) Open the packaging and carefully take out
the power tool.
2) Remove the packaging material as well as the
packaging / transport locks (if any).
3) Check the scope of delivery for completeness
and check the power tool and the accessory
parts for transport damage.
Note: Do not start the power tool if you notice
that parts are missing or damaged. Contact the
retailer where you purchased this power tool.
4) Store the packaging until the end of
the warranty period, if possible. Please
dispose of the packaging in accordance with
environmental regulations and take it to a
recycling depot.
WARNING!
Neither power tools nor packaging
materials are toys!
Children must not play with plastic bags,
foils and small parts! Danger of swallowing
and suffocation!
6.2 Installation
- Fold the front and back part together (B2). And
then tighten the screw nut. (B3).
-The longest length installation
Insert the additional handle to the end of the
machine. And then turn the screw nut on the
end of the machine for tightening. (B4)
6.3 Sandpaper
Selection
1) The grain size of the sandpaper is specified on
its rear side. The smaller the specified number,
the coarser the graining.
2) Use sandpaper with coarse grain for rough
grinding, and sandpaper with fine grain for
finishing. We recommend sandpapers with
aluminium oxide, silicon carbide or other
synthetic abrasives.
3) If you can chose between sandpapers with
different graining, you should start with coarse-
graining sandpaper and complete the grinding
process with the finest possible graining. Thus
you will get good and smooth grinding results.
23