Matrix DWS 710 Notice Originale page 20

e) Maintain power tools with care. Check
moving parts for proper function and
smooth running, and check whether there
are parts which are broken or damaged to
the extent that the functionality of the power
tool is impaired. Have damaged parts repaired
before using the power tool. Many accidents are
caused by poorly-maintained power tools.
f) Keep cutting tools sharp and clean.
Carefully maintained cutting tools with sharp
edges are less likely to jam and can be guided
more easily.
g) Use power tools, accessory parts,
insertion tools, etc. in compliance with these
instructions. Take into account the working
conditions and the activity which is to be carried
out. Using power tools for applications other
than those intended may cause dangerous
situations.
4.5 Service
a) Have your power tool repaired by qualified
specialists only, and always use original
spare parts for repair. This is to maintain the
safety of the power tool.
4.6 Safety notes for all applications - General
safety notes for grinding, sanding, working
with wire brushes, polishing and cutting by
grinding
a) This power tool must be used as a
sandpaper grinder. Observe all safety notes,
instructions, illustrations and data which
are provided together with the tool. Non-
observance of the following instructions may
result in electric shock, fire and/or severe injury.
b) This power tool is not suited for grinding,
operations with wire brushes, polishing and
cutting by grinding. Using the power tool for
applications other than the intended ones may
result in risks and injury.
20
c) Only use accessory parts especially
provided for this tool and recommended by
the manufacturer. The mere fact that you can
mount accessory parts to your power tool does
not ensure safe use.
d) The permissible speed of the insertion
tool must be at least as high as the maximum
speed specified on the power tool. Accessories
with a higher speed may break and fly off.
e) The outer diameter and the thickness
of the insertion tool must comply with the
dimensions specified on your power tool. It is
not possible to shield or control insertion tools
with different dimensions.
f) Grinding disks, flanges, grinding plates or
other accessory parts must exactly mate the
grinding spindle of your power tool. Insertion
tools which do not exactly mate the grinding
spindle of your power tool will perform irregular
rotations, cause high vibrations and thus the
loss of control.
g) Do not use damaged insertion tools.
Prior to each application, you must check
insertion tools such as grinding disks for
chippings and cracks, grinding plates for
cracks, wear or major abrasion, wire brushes
for loose or broken wires. If the power tool or
insertion tool falls down, you must check it
for damages, or use an undamaged insertion
tool. After you have checked and inserted
the insertion tool, both you and persons in
the vicinity must stay out of the level of the
rotating insertion tool, and the tool must be
operated at maximum speed for one minute.
Most of the damaged insertion tools will break
within this test period.
h) Wear personal protective equipment.
Depending on the application of the power
tool, you must wear a full face shield, eye
protection or goggles. If appropriate, you
must wear a dust mask, hearing protection,
protective gloves or a special apron which