Installation Of The Unit - Luxair LMT430SB Instructions D'installation Et Guide De L'usager

WARNING:
BE CAREFUL WHEN INSTALLING THE DECORATIVE CHIMNEY AND HOOD, THEY MAY HAVE SHARP
EDGES.
CAUTION:
DO NOT REMOVE THE PROTECTIVE PLASTIC FILM COVERING THE DECORATIVE CHIMNEY

INSTALLATION OF THE UNIT


Install 6" round adapter/damper on top of the hood using 4 no. 8 x 7/16" mounting screws.

Align the hood and center it above the hood mounting bracket. Gently lower the hood until it
securely engages the bracket.

With the hood hanging in place, drill through both holes located at the back of the hood using
a 5/16" drill bit (Fig. 2).

Insert the included drywall anchors into the drilled holes (one for each hole). Insert 2 no. 8 x
1¼" mounting screws in 2 washers, then insert into the drywall anchors. Verify that the hood is
centered and leveled. Tighten all screws completely.

Remove protective plastic film covering the lower chimney only.

If possible (when space is sufficient): Install the lower chimney bracket to the chimney using 2
no. 8 x 7/16" mounting screws, ensure that the slots point up (Fig. 3).

Carefully place both chimneys on top of the hood. NOTE: Slightly slide up the upper chimney to
avoid damaging it.

Slide a 6" metal round duct over the adapter/damper (Fig. 2). Use metal foil duct tape to seal
the joint.

Plug hood power cord into the outlet.

Slide up the upper chimney until it is aligned with its mounting bracket. The bracket must be
inside the chimney. Secure the upper chimney to its bracket using 2 no. 8 x 7/16" mounting
screws (Fig. 4 and 5).

Remove protective plastic film covering the upper chimney and the hood.
Fig.1 Fig.2
Fig.3
L
OWER CHIMNEY MOUNTING BRACKET
B
ACK VIEW
L
OWER CHIMNEY