Installation Instructions; Before Installing The Hood - Luxair LMT430SB Instructions D'installation Et Guide De L'usager

2. INSTALLATION INSTRUCTIONS

TOOLS NEEDED TO INSTALL THE RANGE HOOD

Philips screwdriver

Hammer and flat blade screwdriver

Sheet metal sheers

Pair of pliers

Scissors (to cut duct tape)

Duct tape

Marker or pencil

Level

Measuring tape

BEFORE INSTALLING THE HOOD


For the most efficient airflow exhaust use a straight run or as few elbows as possible.

Vent unit to the outside only.

Two people are required for installation

Remove the range hood from the carton packaging and place on a flat surface for
assembly.
ELECTRIC REQUIREMENTS
CAUTION
This appliance should be properly grounded.

This hood must be power supplied 120 V, 60 Hz, and connected to an individual, properly
grounded circuit (3-prong outlet)

If the electrical supply does not meet above requirements, call a licensed electrician before
proceeding.

Route house wiring as close as possible to the installation location, in the ceiling or back
wall.

The hood must be connected to the house wiring in accordance with the local codes and
norms .