Time Setting; Maintenance - Luxair LMT430SB Instructions D'installation Et Guide De L'usager

TIME SETTING

This button is used to set time and time is displayed in 24 hour cycle. To set time, press the timer
button (K1) for 4 seconds. The first two digits will flash. Use the blower button " –" (K3) to
decrease and the "+" button (K4) to increase. Press the time/delay button (K1) again, the last two
digits will flash. Use the blower button " –" (K3) to decrease and the "+" button (K4) to increase.
Press the time/delay button (K1) again to confirm and exit time setting mode or wait 5 seconds
and it will automatically exit.

4. MAINTENANCE

SAFETY WARNING: NEVER PUT YOUR HAND INTO AREA HOUSING THE FAN
For optimal operation, clean range hood, surfaces and filter regularly. Regular care will help
preserve the appearance of the range hood.
CLEANING EXTERIOR SURFACES
Clean periodically with hot soapy water and clean cotton cloth. Do not use corrosive or abrasive
detergent, or steel wool/scoring pads, which will scratch and damage the stainless steel surface.
For heavier soil use liquid degrease brand cleaner. Use a stainless steel cleaner to clean the surface
of the hood. Avoid getting cleaning solution onto or into the control panel. Follow directions of the
stainless steel cleaner.
CAUTION
Use soft towel to wipe off the cleaning solution, gently rub off any stubborn spots. Use dry soft
towel to dry the hood. Always scrub lightly, with clean cotton cloth, and in the direction of the
grain.
Do not allow deposits to accumulate or remain on the hood. Do not use ordinary steel wool or
steel brushes. Small bits of steel may adhere to the surface and cause rusting.
Do not allow salt solutions, disinfectants, bleaches, or cleaning compounds to remain in contact
with stainless steel for extended periods. Many of these compounds contain chemicals, which
may be harmful. Rinse with water after exposure and wipe dry with a clean cloth.
CLEANING GREASE FILTER
The mesh filters are intended to filter out residue and grease from cooking and are required to be
kept clean. Filters should be cleaned after every 30 hours of use. Remove and clean by hand in
soapy water or using a dishwasher. Dry filters and re-install. Clean the filters in the dishwasher
using a non-phosphate detergent.