Bresser MikrOkular-II Mode D'emploi page 15

VALUE enter „1". Confirm your
input with OK and then reboot
the computer.
Change to the device manager.
In the VIEW menu activate the
SHOW DEVICES OPTION. The
ghost devices previously not
shown will now be displayed
in light grey. Check the various
categories including USB,
memory size, etc. Only delete
entries for devices you no
1
longer use.
1 Source: Microsoft Knowledge
Base
http://support.microsoft.com/
kb/315539/de
2. Using the MicrOcular
Preparation
1. Slide a specimen under your
microscope and focus on it.
2. Remove the eyepiece and
Barlow lens from the eyepiece
support and the dust cap from
your MikrOkular and install
same in the eyepiece supports
instead of the Barlow lens.
3. Start your PC if you
haven't yet and connect your
MikrOkular to the USB port of
your computer.
2.1 Showing and saving
MikrOkular images on your
PC.
1. Start the Photomizer SE
Software.
2. Click „Open camera"
3. If you have more than one
device connected up select
the one you want from the
choice offered. Click „SoC
PC-Camera" or „MikrOkular".
Omit this step if you only have
a single device connected up.
4. The camera image should
now be visible on your screen.
Focus the microscope image.
5. Click „Capture" to record an
image. It will then be shown on
the right.
6. Click on it to select it and
then click „Transfer image".
7. This takes you to the
Photomizer SE software.
8. File - Save as
GB
15