Adjusting Brush Height; Draining Tanks; Draining Recovery Tank; Draining Leftover Cleaning Solution - Tennant EX-SC- 1020P Manuel Opérateur

OPERATION
EN
WARNING: Fire Or Explosion Hazard. Do Not
Pick Up Flammable Materials Or Reactive Metals.
NOTE: When cleaning upholstery, always check
cleaning instructions sewn in furniture by manufacturer.
6. After operating accessory tool, relieve water
pressure from tool before disconnecting hose.
Squeeze trigger for five seconds after turning off
switches.

ADJUSTING BRUSH HEIGHT

1. Turn off machine and unplug power cord from wall
outlet.
WARNING: Spinning Brush. Keep Hands
Away. Turn Off Power Before Working On Machine.
WARNING: Electrical Hazard. Unplug power
Cord Before Leaving Or Servicing Machine.
2. To adjust brush height, use a standard screwdriver
and turn brush height adjustment lever in 1/4 turn
increments, 4 settings (Figure 7).

DRAINING TANKS

WARNING: Electrical Hazard. Unplug power
Cord Before Leaving Or Servicing Machine.
NOTE: Always use separate buckets when draining
and filling machine.
8
FIG. 7

DRAINING RECOVERY TANK

1. Turn off power switch and unplug power cord.
Raise brush lift handle and transport machine to
draining area.
2. Remove the recovery tank drain hose cap by
turning it counter- clockwise and drain the tank
(Figure 8).
3. After draining, replace drain hose cap securely.

DRAINING LEFTOVER CLEANING SOLUTION

1. Connect the 1m (3 ft) bleeder hose, supplied with
machine, to machine's quick coupler (Figure 9).
2. Direct the hose into a bucket or floor drain.
3. Turn on main power switch.
NOTE: You can also use the bleeder hose to rinse out
recovery tank when there's leftover water.
FIG. 8
FIG. 9
EX- SC- 1020P (04- 10)