Vimar TAB 7 IP Guide Rapide page 9

TAB: 40605
Installation
Important: The device should be installed at a height of approximately 160 cm off the floor, taking care not to expose it to
direct sources of light so as to avoid annoying glare on the surface of the LCD screen.
Note: Fig. 1 shows the recommended installation distances, unless otherwise specified by current regulations.
1. Secure the plate to the wall, with metal bracket, in box: circular 2M (Vimar V71701), 3M (Vimar V71303, V71703) horizon-
tal and vertical, 4+4M (Vimar V71318, V71718) and square, British standard.
2. Connect the RJ45 PLUG of the video door entry system network and, when present, the landing push button, wire the
FP - M terminal block (Fig. 6).
3. Install the video entryphone as follows: position the video entryphone on the plate keeping it slightly raised. While keeping
the front panel pressed, apply a light downward pressure until it clicks into place.
4. Should you need to remove the monitor you need to apply a light pressure on the lever (Fig. 3) and raise it (from the
bottom upwards) so as to release the monitor from the chassis.
Fig. 1
Fig. 2
> 10 cm
EN
1,60 / 1,65m 1,20m
9