IKRA IES 1000 C Manuel D'utilisation page 27

nected and used properly. The use of
these devices reduces hazards caused by
dust.
4) Careful handling and use of power tools
a) Do not overtax the power tool. Use the
power tool intended for your type of work
in each case. The use of the suitable power
tool within the stated range of performance
makes working more effective and safer.
b) Do not use a power tool with a dam-
aged switch. A power tool that cannot be
switched on or off any more is dangerous
and must be repaired.
c) Pull the mains plug out of the socket be-
fore you adjust a tool, change accesso-
ries or put the tool aside. This precaution
avoids the unintentional start of the tool.
d) Store power tools out of the reach of
children. Do not allow persons to use the
tool if they are not familiar with the tool
or these instructions. Power tools are dan-
gerous if used by inexperienced persons.
e) Thoroughly maintain your power tool.
Check whether moving parts are working
properly and are not jamming/sticking,
and whether parts are broken or other-
wise damaged in a way that affects the
function of the tool. Have damaged parts
repaired before using the tool. Many ac-
cidents are the result of poorly maintained
power tools.
f) Keep cutting tools sharp and clean.
Thoroughly looked-after cutting tools with
sharp cutting edges are jamming less often
and are easier to guide.
g) Use power tools, accessories, add-on
tools, etc. in accordance with these in-
structions and in the way prescribed for
the respective type of tool. You should
also consider the working conditions
and the work to be carried out. The use
of power tools for purposes other than
those intended for the respective tool may
result in dangerous situations.
GB | Operating Instructions
5) Service
a) Have the power tool serviced by quali-
Safety Instructions
A. General Instructions
1. Your electric tool is a high-speed, fast-cut-
2. Always switch off the tool and disconnect
3. Have your dealer or a specialist show you
4. Minors should never be allowed to use an
5. The user is responsible for safety for all
6. Never allow children or people unfamiliar
7. Only use the machine in daylight or good
8. Before use the machine and after any
9. Never operate the machine with damaged
10. You must be fit to operate an electric lawn
GB-6
fied technical personnel only; repairs
should be carried out using exclusively
original spare parts. This will ensure the
safe operation of the power tool.
ting power tool. The electrical connection
and cutting tool are potential sources of
danger. Therefore, special safety precau-
tions must be observed to reduce the risk
of personal injury.
the plug from the power supply before car-
rying out any maintenance or repair work
on the unit. Always unplug the tool if you
leave it without supervision.
how to operate your tool.
electric lawn trimmer. Never lend or rent
your electric lawn trimmer without these
operating instructions. Be sure that anyone
using your tool understands the information
contained in these operating instructions.
persons in the working area of the device.
with the instruction to use the machine
artificial light.
impact, check for signs of wear or damage
and repair as necessary
guards or without the guards in place.
trimmer- rested, healthy and in good physi-
cal condition. If you get tired while operat-
ing your scythe, take a break. Never work
with an electric lawn trimmerwhile under
the influence of alcohol or drugs.