Functional Description - Makita GE0600 Manuel D'instruction

alternating current
no load speed
Class II Construction
revolutions or reciprocation per minute
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Switch action
► 1. Switch
CAUTION:
• Before plugging in the tool, always check to see
that the tool is switched off.
• Switch can be locked in "ON" position for ease
of operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
To start the tool, press the "ON ( I )" side of the switch.
To stop the tool, press the "OFF (O)" side of the switch.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing or removing wheel point
CAUTION:
• Use the correct size collet cone for the wheel
point which you intend to use.
• Do not tighten the collet nut without inserting a
wheel point. Otherwise it can lead to breakage
of the collet cone.
► 1. Wrench 17 2. Wrench 10 3. Collet nut
Loosen the collet nut and insert the wheel point into the
collet nut. Use the smaller wrench to hold the spindle
and the larger one to tighten the collet nut securely.
The wheel point should not be mounted more than 10
mm (3/8") from the collet nut. Exceeding this distance
could cause vibration or a broken shaft.
To remove the wheel point, follow the installation proce-
dure in reverse.
NOTE:
• If you cannot insert the wheel point into the
1
collet nut after loosening the collet nut, the collet
cone may obstruct the wheel point. In that case,
remove the collet nut and reposition the collet
cone.
10 mm(3/8")
CAUTION:
• A 1/4" collet cone is provided as standard equip-
ment. Use an optional collet cone 1/8" to install
a 1/8" shank wheel point.
4 ENGLISH
1
2
3